Printable PagePrintable Page Email This PageEmail This Page

Manufacturing Equipment & Installation, Training & Support Services

As a full service provider of advanced stamping, production, automation and fabrication systems, TCR, Inc. also provides comprehensive support services. Manufacturing equipment engineered by TCR features cutting edge technology and state-of-the-art control systems.


TCR provides rapid complete installation services performed by installation professionals with years of system integration experience. All systems are fully OSHA compliant, and include a comprehensive on-site training program. These comprehensive services are backed up by TCR’s staff of journeymen electricians and Millwrights, all with many years of experience. From light mechanical repair and preventive maintenance programs to OSHA compliance surveys, TCR’s detail oriented approach eliminates start up issues and provides long term support.


TCR training programs are done on live systems at your site; operators are thoroughly trained on all systems including all safety features. Because of TCR’s long list of successful projects, trainers can determine and train for the challenges that the operator will face daily. The result for the bottom line is higher productivity and greater efficiency.


To learn more about all of TCR’s value added services, see the table below or contact TCR, Inc. directly.

Manufacturing Equipment Support Capabilities

Support Services
Installation / Service
Training
OSHA Compliance Survey
Preventative Maintenance
Installation / Services
Engineering
Integrate
Supplier Relationships
Journeyman Electricians
Millwright
Precision Alignment
Light Mechanical Repair
Training Available
Punch Press Mechanical Operation
Auxiliary Equipment Support
Die Operation
Interactions Between Equipment
Fundamentals of Punch Press
Advanced Technologies
Safety
Feed Line Setup
Die-Protection
Tonnage Monitor
Integrating Computers
Automation Improvement
Higher Productivity and Efficiency
Challenges Faced by Operators During Daily Operation
OSHA Compliance Survey
On-Site Audits
Identify Non-Compliance and Safety Issues
Develop Custom Programs
Detailed & Confidential Reports
Corrective Action Plans
Preventative Maintenance
Mechanical Punch Press Physical Inspection
Mechanical Punch Press Electrical Inspection
Thermal Imaging
Tonnage Monitor Recalibration
Guarding
Running Clearance Inspection
Bearing Lift
Parallelism Verification
Oil & Filter Changes
Baseline and Database Documentation
Process Improvement
Maintenance Reduction
Other Services
Rapid Startup
On-Site Training
Long-Term Support Following Installation
Elimination of Startup Problems
Optimal Production

Additional Information

Industries Served
Metal Stamping
Fabrication
Products
Stamping Presses
Lasers
Press Brakes
Sheet Hydroforming
Industry Standards Met
National Electric Code (NEC)
Precision Metalforming Association (PMA) Members
OSHA 1910.217
ANSI B11
Industry Terms
Point of Operation Guarding (POG)
Quick Die Change (QDC)
Single Minute Exchange of Dies (SMED)
Down Time Codes (DTC)
Cut To Length (CTL)
Mistake Proofing (Poka-Yolk)
Master Operator Station (MOS)
Efficiency
Continuous Process Improvement
Lean Manufacturing
Just in Time (JIT)
Software
Press Room Networking
Up/Down Time Networking
Real Time Monitoring
Downtime Recording
© 2017 TCR, Inc., All Rights Reserved.Site created by Thomas Web Solutions